收藏本站 | 设为

服务热线:18596277123

News and information

联系我们

地址:山东省德州市陵县经济开发区
联系人:王经理
手机:18596277123
电话:0534-8285863
传真:0534-8285863
邮箱:1448319145@qq.com
当前位置: > > 行业新闻

行业新闻

土工膜焊接机更换上、下压辊英文翻译

文章来源:cstgb 更新时间:2019-01-25 15:01:21

土工膜焊接机电机的更换

  拆下壳体上的所有螺钉,拆下前端盖以拆下壳体,土工膜焊接机拆下支架上的4-M5安装螺钉,拆下主链条护罩并分离上下支架。拆下上支架底部的盖子和电机与保险丝座的焊接连接,拧下电机的2-M5安装螺钉,取下电机并更换新的。将拆下的导线焊接回去,按相反的顺序重新装配(注意:装配时保持上下压辊平行)。

微信图片_20190125144410.jpg

土工膜焊接机更换上、下压辊

  拆下链条护罩,取下两个链轮上的顶出螺钉,然后拆下链轮和链条。对于上部橡胶轮,如果拆下轴承壳上的两个螺钉(即压板两侧的两个螺钉),则可以将其拆下。对于下胶轮,如果链轮一侧的轴承可以拆下。用同样的方法重新组装它们。

Replacement of motor

Remove all screws on sing, remove front end covering to remove housing, remove the 4-M5 installation screws on the support, remove the main chain guard and separate the upper and lower support. Remove the covering on the bottom of upper support and weld connection between motor and fuse holder, screw off the 2-M5 installation screws of the motor, take off motor and replace a new one. Weld back the removed wires and reassemble on the opposite sequence (Note: keep upper and lower pressure roller is parallel during assembling.).  

微信图片_20190125144410.jpg

Replacing of upper and lower pressure roller

Remove the chain guard, take off the forcing off screws on the two chain wheels and then remove chain wheel and chain. For upper rubber wheel, it can be removed if the two screws on bearing housing that on both sides of press plate are removed. For lower rubber wheel, it can be removed if the bearing on one side of chain wheel. Reassemble them in the same method.